V2000-c Rfid Access Control User Manual ((better)) -

Press 2 ➔ Enter 0000 ➔ Press # . (Warning: This clears all database memory) . Door Unlock and Relay Configuration

Proper wiring is critical to avoid damaging the unit or the connected electronic locks. Always disconnect the power supply before wiring. Terminal Configurations : Power Positive (+12V DC) BLACK : Power Negative (GND)

: Verify if your lock is Fail-Safe (NC) or Fail-Secure (NO). Ensure the common wire runs through the COM terminal. If using a heavy-duty magnetic lock, power it using an independent access control power box rather than drawing directly from the keypad loop. Issue 3: The keypresses do not register V2000-c Rfid Access Control User Manual

Are you looking for a reliable and efficient access control solution for your organization? Look no further than the V2000-C RFID Access Control System. This user manual provides a detailed guide on how to install, configure, and operate the V2000-C system, ensuring that you get the most out of your access control investment.

The V2000-C RFID Access Control is a waterproof, standalone single-door system supporting up to 2,000 users with RFID card or PIN authentication. It features an adjustable relay for electronic locks, operating on 12V DC, with programming that includes setting user cards, PINs, and access modes. For official digital copies, you can access the Obohands English Manual Download from the manufacturer's site. RFID Access Control System User Manual - uAmper Press 2 ➔ Enter 0000 ➔ Press #

Connect the other wire of the push button to the terminal. 4. Programming Guide

1.0 Last Updated: 2026 Applies to: V2000-C Standalone RFID Access Control System Always disconnect the power supply before wiring

Connect the terminal of the Magnetic Lock directly to the power supply +12V . Wiring an Exit Button