: Use the provided template to mark the screw positions and the cable entry point on the wall.
Modern TS1162 units often require a digital handshake upon first power-up.
of the data cable shield to the device’s LAN earth terminal to prevent ground loops. Step 3: Mounting and Final Connections Elias mounts the keypad about 1.5 m from the ground for ergonomic use. He then: Connects the RTE input: ts1162 installation manual exclusive
Torque all terminal screws to 4.5 in-lbs (0.5 Nm) to ensure a secure, spark-free connection. 2. Data and Interface Integration
Connect the primary fiber optic cable to Port 0 . Use Port 1 strictly for multi-pathing or redundant fabric topologies. : Use the provided template to mark the
: Connect to the positive differential transmission line of the RS-485 data bus.
: Connect to the +12V DC power bus from the Challenger panel or local power supply. Negative (-) : Connect to the 0V system ground. Data A : Connect to the RS-485 LAN 'A' terminal line. Data B : Connect to the RS-485 LAN 'B' terminal line. Input & Output Tail Wires Step 3: Mounting and Final Connections Elias mounts
Maintain a minimum cable bend radius of 30 mm to prevent signal attenuation. Ethernet Management Connection
For Direct Attached Storage (DAS) setups, toggle the port mode to .
Set the physical DIP switches on the rear of the TS1162 to match the programmed address in the panel. Ensure there are no overlapping addresses on the same LAN segment. Step 2: Defining Keypad Options
Push the drive firmly into the bay until the blind-mate connectors engage fully with the library backplane.