How to use the MKS Laser Tool if it you can't click on the buttons.
After installation, navigate to the install folder. Find config.ini . Open it in Notepad. Change PollingRate=100 to PollingRate=50 . This doubles the refresh rate of the laser status bar, giving you real-time feedback.
Navigate directly to the official Makerbase MKS-DLC32 GitHub repository. mks laser tool setup v112exe download better
The MKS Laser Tool is a proprietary utility developed by Makerbase specifically for their line of DLC32 control boards. While open-source senders like LaserGRBL and LightBurn are used for everyday designing and burning, the MKS Laser Tool serves as the essential bridge for hardware management.
Once open, the clean graphical interface presents three primary tools essential for managing your machine layout. Update Firmware on Longer Ray5 10W How to use the MKS Laser Tool if
There was a readme, but the important thing was the prompt at the top: Calibrate? [Y/N]. He pressed Y.
Use the parameter config tool to define motor directions, steps per mm, and maximum speed based on your laser machine specifications. Open it in Notepad
Connect your CNC machine to your local network to enable wireless control and file transfers.
The digital workshop was silent, save for the rhythmic hum of a 3D printer in the corner. Elias stared at his new controller board, a sleek piece of hardware that promised to turn his hobbyist laser engraver into a professional-grade machine. He had the hardware mounted, the wiring tucked neatly into looms, but he was missing the soul of the machine: the software.
Once the board connects, it will output an IP address on its touchscreen display (if equipped). Write this IP address down—you can input it directly into LightBurn under a "TCP" device connection to run your laser completely wirelessly. 3. Image Transfer & NC Uploads