The PROBO PR70 is equipped with a manual release feature for use during a blackout or system fault. This releases the operator's transmission, allowing you to move the door by hand.
Hold the radio control key until the green LED lights up briefly, indicating successful identification montaza.lv Wait 15 seconds or press F1 twice to exit montaza.lv Travel Learning
: Lift the operator and insert its splined protruding drive shaft directly into the drive receiving block hole on the pre-assembled runner rail. Do not force or misalign the keyway tab. The PROBO PR70 is equipped with a manual
After the operator is correctly assembled onto the runner, follow these steps to mount the entire assembly to the ceiling:
from the gate moving area during operation. Do not force or misalign the keyway tab
: Briefly press the blue button, transmit with the remote, and press the blue button again. Adjustments :
Open the door to the desired height, position the opening stop against the carriage, and fix it in place. 3. Electrical Connections & Programming Adjustments : Open the door to the desired
: Use the yellow button; LEDs represent times from 5 to 120 seconds. 🔧 Maintenance and Manual Use
until door reaches desired fully open position.
before installing or servicing the automation system.