Deckma Omd11 Manual Jun 2026

: The unit is IP 65 rated for protection against water jets and dust, measuring approximately Technical Specifications Specification Measurement Range 0 – 30 ppm (Trend indication up to 50 ppm) plus or minus 5 ppm around the 15 ppm threshold per IMO standards Power Supply 24V AC/DC (standard); other voltages available on request Sample Temperature Operates between positive 1 raised to the composed with power 60 raised to the composed with power Response Time Adjustable alarm delays between 2 and 20 seconds Operational Guidelines Installation

This is where ignoring the manual leads to catastrophic false alarms or, worse, failure to detect an actual crankcase explosion.

| Alarm Type | LCD Display | Likely Cause (per manual) | Action | | :--- | :--- | :--- | :--- | | | ALARM + High value | Real oil mist (piston blow-by, bearing hot spot) | Slow engine, investigate crankcase. | | Pre-Alarm | PRE-ALARM | Rising mist or sensor drift | Increase monitoring, check scavenge fires. | | Fault Alarm | FAULT + Code E-01 to E-12 | Electronic failure, no airflow, lens broken | Check blower motor, wiring, fuse F2. | | Low Flow | FLOW ERROR | Blocked sampling tube, blower impeller stuck | Blow out tube with compressed air (careful: 0.5 bar max). |

If the main logic board requires replacement: deckma omd11 manual

If you are a Chief Engineer, the physical binder should be in the ship’s library. However, in a digital age, the is the most searched document. Here is where to find it legally:

: Run clean water through the unit to confirm a 0 ppm reading. 🔍 Troubleshooting Error Codes "EE" Code on Display Meaning : Memory read error or microprocessor failure.

Mount the unit on a rigid vertical surface using 4 x M5 screws. : The unit is IP 65 rated for

This comprehensive guide serves as an operational reference based on the official protocols, detailing the device specifications, installation requirements, system programming, maintenance routines, and troubleshooting procedures. Key Technical Specifications

Install a valve if the sample pressure exceeds 10 bar. 4. Electrical Connections and Wiring

0 – 30 ppm (linear indication up to 15 ppm, progressive up to 30 ppm). | | Fault Alarm | FAULT + Code

Given that the OMD-11 is an older unit, eventual component failure is inevitable. The manual's final sections include lists of recommended onboard spare parts and addresses for getting support.

A digital or moving-coil meter showing the current oil concentration.

If the OMD-11 displays an error or gives false alarms, consult the troubleshooting section of the manual:

. Although now considered an older model and no longer in production, it remains widely supported for calibration and spare parts. Technical Specifications

: Use mild dish soap or specialized oil solvent.